Miller-electric Blue Star 6000 User Manual download pdf (Page 31)

OM-499 Page 27

Return To Table Of Contents

8-5. Adjusting Engine Speed (Honda-Powered Units)

802 097-A

After tuning engine, check engine

speeds. See table for proper no

load speeds. If necessary, adjust

speeds as follows:

Start engine and run until warm.

Weld/Power Speed

Adjustment

1 Throttle Control Lever

2 Adjustment Screw

Move lever to Run (60 Hz) position.

Turn screw and move lever until en-

gine runs at weld/power speed.

Idle Speed Adjustment

3 Pilot Screw

4 Throttle Stop Screw

Move lever to idle position. Turn pi-

lot screw until engine runs at high-

est idle speed. Turn stop screw until

engine runs at rated idle speed

(normally about 2-1/4 turns out.)

 Stop engine. Close fuel

valve.

1/4, 3/8 in

Tools Needed:

1400 ± 150 rpm

3720 ± 50 rpm (60 Hz)

3250 ± 50 rpm (50 Hz)

2

1

3

4

1 ... 30 31 32 ... 60

Comments to this Manuals

No comments