Miller-electric DVI-2 R User Manual download pdf (Page 19)

.A complete Parts List is available at www.MillerWelds.com

OM-232 386 Page 15

4-7. Installing Gas Supply

Ref. 804 654-A / Ref. 804 898-A

Tools Needed:

Obtain gas cylinders and chain to

running gear, wall, or other

stationary support so cylinders

cannot fall and break off valve.

1 Cap

2 Cylinder Valve

Remove cap, stand to side of valve,

and open valve slightly. Gas flow

blows dust and dirt from valve.

Close valve.

3 Cylinder

4 Regulator/Flowmeter

Install so face is vertical.

5 Regulator/Flowmeter Gas

Hose Connection

6 Welding Power Source Gas

Hose Connection For MIG

Gun

Connect gas hose between

regulator/flowmeter gas hose

connection, and fitting on rear of

welding power source.

7 Gas Flow Adjustment Control

Typical flow rate is 25 cfh (cubic feet

per hour). Check wire

manufacturer’s recommended flow

rate.

8 CO2 Adapter (Customer

Supplied)

9 O-Ring (Customer Supplied)

Install adapter with O-ring between

regulator/flowmeter and CO

cylinder.

1-1/8, 5/8 in

Rear Panel

Argon Gas Or Mixed Gas

Gas

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

No comments

Miller-electric DVI-2 R User Manual Page 19