Miller-electric 225 User Manual download pdf (Page 19)

OM-316 Page 15

4-5. Installing Electrode Holder And Work Clamp

802 251 / 802 105-C

Y Turn Off unit and disconnect

input power before installing

electrode holder or work

clamp.

Removing Barrel From Elec-

trode Holder

1 Electrode Holder

2 Barrel

3 Access Hole

4 Set Screw

Loosen set screw through access

hole and slide barrel away from

electrode holder.

Installing Electrode Cable and

Barrel onto Electrode Holder

5 Electrode Cable From Unit

(Has Bare Conductors on

End)

6 Terminal Screw

Back out terminal screw from elec-

trode holder. Insert electrode cable

through barrel into end of electrode

holder and tighten terminal screw

securely.

Move barrel toward electrode hold-

er and tighten set screw to secure

barrel in place.

Installing Work Cable onto Work

Clamp

7 Work Clamp

8 Work Cable From Unit (Has

Ring Terminal on End)

9 Mounting Bolt

Route work cable through work

clamp as shown and install onto

mounting bolt using supplied hard-

ware.

1/4 in

Tools Needed:

1/2 in

4-6. Weld Output Cables

For weld output cable replacements or extensions, contact your Factory

Authorized Service Agent.

NOTE

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Comments to this Manuals

No comments

Miller-electric 225 User Manual Page 19

Comments to this Manuals

Related products and manuals for Tools Miller-electric 225