Miller Electric MC-80 Owner's Manual download pdf (Page 37)

 POINTER ROD: The Pointer Rod is located in the Front of the Curbilder. The operator

who is steering the machine while curb is being placed uses the Pointer Rod to follow a

chalk or string line on the ground to place the curb in the correct location on the job.

When the Curbilder is in the correct position to begin placing the curb and the chalk or

string line has been placed on the ground (see 6, “Laying Out the Job Site” above)

adjust the Pointer Rod 1” above the ground and directly over the reference string. Then

tighten the retention bolt. To avoid damaging the Pointer Rod when loading the

Curbilder onto a trailer or lifting the machine with a crane, loosen the retention bolt and

lift the Pointer Rod bottom end 6” or more above the ground.

Note: The Pointer Rod is assembled at the factory on the front of the Front Wheel

Support. When it is required to move the Pointer Rod to the front of the Curbilder

Frame a SHORTER retaining bolt is required. See drawing below for the correct

bolt size for each location for each Curbilder model. Caution: Do not use a bolt

length other than what is specified or the bolt will not tighten all the way and/or there

will be interference between the bolt and other parts.

 EMERGENCY STOP SWITCH(ES): Refer to the “SAFETY” section of the manual,

“Operation of this Equipment”, E.1. and “Operating the Curbilder,” page 29. Locate ALL

of the Emergency Stop Switch(es) on your machine. In the event of an Emergency,

know how to stop the Engine/Auger on the Curbilder using these switch(es).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 54 55

No comments

Miller Electric MC-80 Owner's Manual Page 37