Miller Electric MC-80 Owner's Manual download pdf (Page 35)

 REAR TAIL WHEEL ASSEMBLY: The Rear Tail Wheel Assembly consisting of

the Holding Bracket and Vertical Upright Tube with wheels should be mounted

with the Holding Bracket and Vertical Tube to the Rear of the Main Frame Rear

Cross Tube.

To adjust the LATERAL LOCATION of the Rear Tail Wheel Assembly turn the

crank handle CLOCKWISE until the rear wheels are 1” above the ground. Then

loosen the one (1) 3” long vertical retention Bolt on the Holding Bracket to move

the Rear Tail Wheel Assembly. Slide the Rear Tail Wheel Assembly to the Left or

Right so that the wheel closest to the curb form is no closer than 2” from the inside

edge of the curb form. Tighten the one (1) vertical retention bolt.

Note: When the Curb Form to be used is over 10” tall the Rear Wheel Outer

Upright Tube can be repositioned vertically down to gain additional height

of the frame of the Curbilder.

To Adjust the VERTICAL HEIGHT POSITION of the rear of the Curbilder frame

upward, raise the rear of the Curbilder frame as shown using the Rear Tail Wheel

Assembly. Insert two(2) jack stands under the rear of the Curbilder frame.

Loosen and remove the two (2) 3-1/2” long horizontal retention bolts on the

Holding Bracket. Then LOWER the Rear Tail Wheel Outer Tube by turning the

crank handle CLOCKWISE and at the same time pushing this tube down until the

slots in the next lower tube position can be lined up with the square holes in the

Rear Tail Wheel Bracket. Each lower slot position gains 2-1/4” vertical rear height

of the Curbilder. When the desired position is achieved, replace and tighten the

two (2) horizontal retention bolts. Remove jack stands.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 54 55

No comments

Miller Electric MC-80 Owner's Manual Page 35