Miller Electric OM-230 Operations Instructions download pdf (Page 3)

OM-263 230 Page 1

SECTION 1 − SAFETY PRECAUTIONS -

READ BEFORE USING

OXY FUEL 2013-06

Protect yourself and others from injury — read, follow, and

save these important safety precautions and operating in-

structions.

1-1. Symbol Usage

DANGER! − Indicates a hazardous situation which, if not

avoided, will result in death or serious injury. The possible

hazards are shown in the adjoining symbols or explained

in the text.

Indicates a hazardous situation which, if not avoided,

could result in death or serious injury. The possible haz-

ards are shown in the adjoining symbols or explained in

the text.

NOTICE − Indicates statements not related to personal injury.

. Indicates special instructions.

This group of symbols means

Warning! Watch Out! ELECTRIC

SHOCK, MOVING PARTS, and

HOT PARTS hazards. Consult

symbols and related instructions below for necessary actions to avoid

the hazards.

1-2. Welding, Cutting, Brazing, Heating Hazards

The symbols shown below are used throughout this manual

to call attention to and identify possible hazards. When you

see the symbol, watch out, and follow the related instructions

to avoid the hazard. The safety information given below is

only a summary of the more complete safety information

found in the Safety Standards listed in Section 1-4. Read and

follow all Safety Standards.

Only qualified persons should install, operate, maintain, and

repair this equipment.

During operation, keep everybody, especially children, away.

Do not use this equipment unless you are trained in its proper

use or are under competent supervision. Follow the proced-

ures described in this booklet every time you use the equip-

ment. Failure to follow these instructions may cause fire, ex-

plosion, asphyxiation, property damage, or personal injury.

This equipment must be used in accordance with all Federal,

State, and local regulations as well as DOT (Department of

Transportation) and CGA (Compressed Gas Association) reg-

ulations. Contact your gas supplier for more information on

the proper use of compressed gases.

. In this document, the phrase “welding and cutting” also refers to oth-

er oxy-fuel operations like brazing and heating.

1 2 3 4 ... 20

Comments to this Manuals

No comments

Miller Electric OM-230 Operations Instructions Page 3

Comments to this Manuals

Related products and manuals for Welding System Miller Electric OM-230