Miller Electric HWY-210 Owner's Manual download pdf (Page 5)

safety_trailer 2/98

LOOSE OR INCORRECT HARDWARE AND

FASTENERS can cause injury and damage.

1. Periodically double-check all nuts and bolts for tightness and

condition.

2. If necessary, always replace any fastener with one of equal

size, grade, and type.

3. Be sure the grade marks on replacement fastener match the

original bolt. The manufacture’s identification mark is not critical

and does not matter for the replacement fastener.

Grade Marks.

Manufacturer’s

Identification Mark

PRE-TOWING CHECKLIST

Check gross trailer weight, tongue weight, and total weight distribution – do not overload this trailer.

Check that the correct hitch is properly installed on towing vehicle.

When coupling, check that coupler locking device (safety pin), safety chains, and breakaway cable (if applicable) are properly connected.

Check that tires are properly inflated and that wheel nuts are properly torqued.

If applicable, check that all lights are working properly.

PRINCIPAL SAFETY STANDARDS

Trailer & Camper Safety, Publication # DOT HS-802586, from U.S. De-

partment of Transportation, National Highway Traffic Safety Adminis-

tration, Washington, D.C. 20590

Safety and Health Standards, OSHA 49 CFR 200 to 999, from Superin-

tendent of Documents, U.S. Government Printing Office, Washington,

D.C. 20402

SAE Handbook. 1996. Volume 4. On-Highway Vehicles and Off-High-

way Machinery, from Society of Automotive Engineers, Inc., 400 Com-

monwealth Drive, Warrendale, PA 15096-0001.

REPORTING SAFETY DEFECTS

If you believe that your vehicle has a defect which

could cause a crash or could cause injury or death,

you should immediately inform the National Highway

Traffic Safety Administration (NHTSA) in addition to

notifying MILLER Electric Mfg. Co.

If NHTSA receives similar complaints, it may open an

investigation, and if it finds that a safety defect exists

in a group of vehicles, it may order a recall and remedy

campaign. However, NHTSA cannot become

involved in individual problems between you, your

dealer, or MILLER Electric Mfg. Co.

To contact NHTSA, you may either call the Auto

Safety Hotline toll-free at 1-800-424-9393 (or

366-0123 in Washington, D.C. area) or write to:

NHTSA, U.S. Department of Transportation,

Washington D.C. 20590. You can also obtain other

information about motor vehicle safety from the

Hotline.

mod11.1 8/94

1 2 3 4 5 6 ... 20

Comments to this Manuals

No comments

Miller Electric HWY-210 Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for Welding System Miller Electric HWY-210