OM-699 Page 5
3-4. Installing Light Kit
ST-802 074-A
LEFT
RIGHT
To TrailerTo Vehicle
Sidelight
Ground
(White)
Taillights
(Brown)
Right Stop/
Signal Lamps
(Green)
Taillights
Tools Needed:
7/16, 9/16 in
Wiring Connections:
Brown Lead
1
3
2
Green Lead
Brown Lead
Yellow Lead
Sidelight
White Ground Lead
(Ground To Trailer Frame)
Short Lead
Left Stop/
Signal Lamps
(Yellow)
Short Lead
Tab Connectors
4
Y Support trailer with jack. Block
wheels.
. Use hardware in green bag to install
lights.
. Use supplied wire to route harness leads
through trailer frame.
1 Wiring Harness White Ground Lead
Strip insulation from end of white ground lead
and crimp on supplied ring terminal. Attach
ground lead ring terminal to chain bracket us-
ing 3/4 in sheet metal screw.
Locate holes for routing wire near each tail-
light.
Route brown and green leads inside of right
frame to exit hole. Route brown and yellow
leads inside left side.
2 Grommet
Route leads through grommets. Install grom-
mets in holes in trailer frame.
Strip 1/2 in (12.7 mm) insulation from ends of
brown, green, and yellow leads.
3 Taillight
Insert stripped end of green lead into right tail-
light hole marked STOP & TURN (GREEN).
Insert stripped end of yellow lead into left tail-
light hole marked STOP & TURN (YELLOW).
Insert stripped end of brown leads into TAIL
(BROWN) holes in each light.
Mount lights on brackets using supplied 1/4
nuts.
4 Sidelight
Pull a small length of brown lead thru hole in
side of trailer.
Splice sidelight short lead to wiring harness
brown lead using supplied tab connector (see
Section 3-5).
Mount sidelight on frame using supplied self-
tapping screws.
Install other sidelight the same way.
5 Sleeving
Install sleeving on taillight and harness plug
electrical leads.
6 Hanging Cable Tie
Install cable tie in 1/4 in (6 mm) hole in bottom
of tongue. Use tie to secure harness and
sleeving.
7 End Cap
Install caps in end of trailer.
5
6
5
7
1/4 in
Comments to this Manuals