Miller Electric Millermatic 212 Auto-Set Owner's Manual download pdf (Page 19)

.A complete Parts List is available at www.MillerWelds.com

OM-238 118 Page 15

4-8. Connecting Spool Gun

A. Spoolmate 200

805 243-A / 243 737-A

1 Gun Trigger Plug

Insert plug into receptacle, and

tighten threaded collar.

2 Weld Cable

3 Shielding Gas Hose

Route weld cable through opening

in front panel.

Route gas hose along side panel or

if unit has a hole in the rear panel,

gas hose can be routed through

wire compartment.

4 Positive Weld Output Terminal

Connect weld cable to weld output

terminal.

5 Regulator/Flowmeter

Route shielding gas hose up to

regulator/flowmeter. Connect gas

hose to fitting on regulator/flowmeter.

.Two welding guns, a MIG gun

and a spool gun, can be

connected to the welding

power source at the same time,

but only one welding gun may

be in use at any one time. If the

triggers of both welding guns

are pulled at the same time, the

weld output and wire feed

motor are disabled.

Tools Needed:

3/4, 5/8 in.

1 ... 18 19 20 ... 48

No comments

Miller Electric Millermatic 212 Auto-Set Owner's Manual Page 19